DAP-1522 A1 factory to snapshot kernel panic and system halt
Username: Dan Mero
Origin: https://bugs.openwrt.org/index.php?do=details&task_id=1586
DAP-1522 A1 stock firmware 1.21 or 1.42 , device page
https://openwrt.org/toh/hwdata/d-link/d-link_dap-1522_a1
Flash via
GUI
or Recovery interface , both the same result/fail.
Since this device is not supported on 17.04.1
https://downloads.lede-project.org/releases/17.01.4/targets/ramips/rt288x/
I try the snapshot from
Checksum ok
Here is the boot log
U-Boot 1.1.3 (Aug 28 2009 - 15:47:01) Build 001--ALPHA_v011
Board: RT2880 DRAM: 32 MB twe0 set to toe0 set to
ASIC -VerB/C (MAC to MAC Mode) DRAM COMPONENT=256Mbits DRAM BUS=16BIT Total memory = 32Mbytes Date:Aug 28 2009 Time:15:47:01
Eth0 (10/100-M)
Hit any key to stop autoboot: 0
Booting image at bc440000 ...
Image Name: 7zip Linux Kernel Created: 1970-01-01 0:00:00 UTC Image Type: MIPS Linux Kernel Image (lzma compressed) Data Size: -1 Bytes = 4096 MB Load Address: 8a000000 Entry Point: 8a000000 Uncompressing Kernel Image with LZMA ... OK
Starting kernel ...
[ 0.000000] Linux version 4.14.48 (buildbot@slashdirt-02) (gcc version 7.3.0 (OpenWrt GCC 7.3.0 r7172-f60301db)) #0 Sat Jun 9 20:39:17 2018 [ 0.000000] SoC Type: Ralink RT2880 id:2 rev:0 [ 0.000000] bootconsole [early0] enabled [ 0.000000] CPU0 revision is: 0001906c (MIPS 4KEc) [ 0.000000] MIPS: machine is D-Link DAP-1522 A1 [ 0.000000] Determined physical RAM map: [ 0.000000] memory: 02000000 @ 08000000 (usable) [ 0.000000] Wasting 1048576 bytes for tracking 32768 unused pages [ 0.000000] Initrd not found or empty - disabling initrd [ 0.000000] Primary instruction cache 16kB, VIPT, 4-way, linesize 16 bytes. [ 0.000000] Primary data cache 16kB, 4-way, VIPT, no aliases, linesize 16 byt es [ 0.000000] Zone ranges: [ 0.000000] Normal [mem 0x0000000000000000-0x0000000009ffffff] [ 0.000000] Movable zone start for each node [ 0.000000] Early memory node ranges [ 0.000000] node 0: [mem 0x0000000000000000-0x0000000009ffffff] [ 0.000000] Initmem setup node 0 [mem 0x0000000000000000-0x0000000009ffffff] [ 0.000000] random: get_random_bytes called from start_kernel+0x8c/0x47c with crng_init=0 [ 0.000000] Built 1 zonelists, mobility grouping on. Total pages: 40640 [ 0.000000] Kernel command line: console=ttyS0,57600 rootfstype=squashfs,jffs 2 [ 0.000000] PID hash table entries: 1024 (order: 0, 4096 bytes) [ 0.000000] Dentry cache hash table entries: 32768 (order: 5, 131072 bytes) [ 0.000000] Inode-cache hash table entries: 16384 (order: 4, 65536 bytes) [ 0.000000] Memory: 25248K/163840K available (3518K kernel code, 174K rwdata, 844K rodata, 1216K init, 214K bss, 138592K reserved, 0K cma-reserved) [ 0.000000] SLUB: HWalign=16, Order=0-3, MinObjects=0, CPUs=1, Nodes=1 [ 0.000000] NR_IRQS: 256 [ 0.000000] Failed to request intc memory [ 0.000000] Kernel panic - not syncing: Failed to request resources for ralin k,rt2880-sysc [ 0.000000] Rebooting in 1 seconds.. [ 0.000000] Reboot failed -- System halted
Regards,